Vehicle Mounting...
1. Place the assembled safe unit into the required position (for example in the passenger foot-well for single driver vehicles or any floor area of the vehicle where the surface is flat). Check that it will not foul door, boot lids, openings etc, and that the under floor area is clear below to accept the Anchor Plate.
2. Remove the safe from its base and mark vehicle floor through fixing holes in Base.
3. Drill 1 x 12.0mm Diameter hole in each marked position.
4. Drop 10mm screws (provided) through each hole, and with Anchor Plate held in position from below, tighten screws.
5. Fit 2 x M10 lock nuts (provided) to bottom of protruding screws, tighten to captive nuts in Anchor Plate.
6. Grind or saw excess thread from bottom of protruding screws and coat with protective paint.
Concrete or Wooden Floors...
1. All of our safes are also suitable for mounting onto solid floors using M10 x 40 Rawl-bolts.
2. See steps 1, 2 & 3 above.
3. Care should be taken when tightening, do not over tighten.
Please Note: 'Complete Unit' safes are supplied with base plates.
